• Stripper 160615

Maintenance & Oil Levels

Recommended maintenance, type of oil & oil levels

Shelbourne Reynolds recommends using fully synthetic 75w90 Oil. Oil should be replaced annually. New machines should have the oil replaced after the first 20 hours of use.

CX/RX Heads:

 Gearbox

Capacity 

 Dropbox

 1.32 Quarts/Litres

 Five Speed

 1.32 Quarts/Litres

 Rotor Box

 1.59 Quarts/Litres

Grease the PTO cross joints at 10 hour intervals. Grease the rotor end bearings and centre ball coupling every 50 hours.

 

Seasonal Maintenance:

Clean machine, remove auger inspection covers & clean out, check auger finger wear, check seals on gearbox, check auger clutch, sprockets & chains, remove panel from rotor & clean out inside rotor, check shafts & rotor bearings for wear.

 

CVS/RVS/RSD Heads:

 Gearbox

Capacity 

 Input Gearbox

 1 Quarts

 Rotor Gearbox

 1 Quarts (where fitted)

Grease the PTO cross joints & the front & rear pulley sheaves at 10 hour intervals, after greasing the pulley sheaves run the variable speed from its slowest speed to its fastest speed to prevent pulleys from sticking. Grease the rotor end bearings, centre ball coupling, LH end ball coupling, gauge wheel pivots on XCV header and auger center ball coupling on XCV36/42 every 50 hours of use.

Seasonal Maintenance:

Clean machine, remove auger inspection covers & clean out, check auger finger wear, check seals on gearbox, check auger clutch, sprockets & chains, remove panel from rotor & clean out inside rotor, check shafts & rotor bearings for wear. Check XCV adapter plate seals for wear and auger center paddles.

Shelbourne recommends using ONLY high temperature fully synthetic grease on Pulley Sheaves.

Follow us on facebook Follow us on twitter View our Youtube channel