Trouble Shooting

The Header is leaving grain on the head
Speed up the stripping rotor also check fingers for wear

The Header is tearing the complete head off
Slow down the stripping rotor

There is excessive Header loss
Slow the rotor speed and increase ground speed

The auger is plugging
Check there is at least 3/4” clearance under the auger

The combine is not feeding smoothly
See if the adaptor plate can be adjusted to reduce the dead area between the feeder chain and auger

Lower heads are being missed
Lower the Header and raise the crop deflector

Grain can be seen shooting out from underneath the front of the crop deflector
Lower the Header and/or the crop deflector